China S6061-04D Standard Damper Actuator (Non Fail-Safe Damper Actuators) Manufacturer and Supplier

S6061-04D Standard Damper Actuator (Non Fail-Safe Damper Actuators)

The damper actuator is specially designed for small and middle air damper and terminal control unit of air volume system. Due to the small size and flexible control, usually used in space where is limited.

There is a characteristic of this damper actuator, the hammer type adapter combines the rotation angle and position indicate.

Features of S6061-04D Standard Damper Actuator (Non Fail-Safe Damper Actuators)

2 or 3 points
Torque 04NM
Power supply AC/DC 24V or AC 230V
The Actuator and damper shaft are bolt-on by screw.
Can parallel connections 20 actuators at most.
Maximum round shaft φ16 and square shaft 12mm.
Manuel Override
With 2 auxiliary switches are optional

Technical Datasheet of S6061-04D Standard Damper Actuator (Non Fail-Safe Damper Actuators)

Item	Unit	S6061-04DN(F)	S6061-04DN(F)
Torque	Nm	4
Damper area	m²	1
Running time	sec	30~40
Power supply	V	24VAC/DC	230VAC
Frequency	Hz	50/60
Running consumption	W	4.0
Maintaining consumption	W	3.0
Weight	Kg	1.0
Control signal		2/3 point
Position signal		potentiometer
Rotation angle		0~90º（Max 93º）
Limited angle		5～85º（per step 5º）
Life cycle		>70 000
Noise Level		45dB(A)
Electrical level		Ⅱ
Protection level		IP44 or IP54
Ambient Temperature		-20~+50℃
Ambient Humidity		5-95%RH
Storage temperature		-40~+70℃
Certificate		CE/ UL	CE

Remark: After lead to the actuator wire through the PG joint, the protection level can reach IP54.

Wiring Diagram of S6061-04D Standard Damper Actuator (Non Fail-Safe Damper Actuators)

On/off type

There are 2 auxiliary switches of the actuator, and you can set the angle 0-90° (the factory sets a is 10° and b is 80°). It will output a on/off signal when the actuator rotates the setting angle. (There is no auxiliary switch of modulating type).

s6061-04d-standard-damper-actuator-non-fail-safe-damper-actuators-2